AMENDMENT FOR PRINTED BILL
1074mg

___________________ moved that HB 1074 be amended as follows:

     On the previously adopted amendment (1074md), between Sections 6 and 7, insert:

     Section 7. That section 1 of chapter 93 of the 2006 Session Laws be amended to read as follows:

     Section 1. The Board of Regents may contract for the construction, completion, furnishing, equipping, and maintaining of, including heating air conditioning, plumbing, water, sewer, electric facilities, architectural and engineering services, asbestos abatement, and such other services as may be required to construct, a new dairy manufacturing plant at South Dakota State University in Brookings, in Brookings County, at an estimated cost of four million dollars five million eight hundred fifty-two thousand dollars and which may not exceed twenty-three thousand nine hundred fifty-two gross square feet .

     Section 8. That chapter 93 of the 2006 Session Laws be amended by adding thereto a NEW SECTION to read as follows:

     Notwithstanding any other restriction in this Act to the contrary, the total project cost authorized for the projects identified in section 1 of this Act may be increased by donations and grants received by the Board of Regents for the purposes of this Act, and the Board of Regents is hereby authorized to expend such grants and donations for the construction, completion, furnishing, equipping, and maintaining of, including heating, air conditioning, plumbing, water, sewer, electric facilities, architectural and engineering services, asbestos abatement, removal of existing roofing and structures, and such other services and improvements as may be required to erect the dairy manufacturing plant. However, no adjustments to any cost estimate may exceed one hundred twenty- five percent of the authorized expenditure authority stated in section 1 of this Act or one hundred ten percent of the gross square footage authorized by section 1 of this Act; provided that increases in gross square footage estimates may be made only to accommodate design changes needed to comply with building code requirements, to address unforeseeable structural, subsoil, or environmental conditions, or to accommodate building program changes in the facility design plan.